R50/R53 :: Hatch Talk (2002-2006) Cooper (R50) and Cooper S (R53) hatchback discussion.

R50/53 Need help: VIN sticker placement on doorjamb

Thread Tools
 
Search this Thread
 
  #1  
Old 09-06-2013 | 10:23 AM
Marquette MINI's Avatar
Marquette MINI
Thread Starter
|
2nd Gear
Joined: Jan 2006
Posts: 89
Likes: 8
Need help: VIN sticker placement on doorjamb

Several months ago I had both my rear quarter panels replaced under warranty on my 2006 MCS for rust damage underneath the taillights. In the process, the body shop failed to transfer or replace the VIN and tire pressure stickers, which I noticed about a month after. I went back and forth with the dealer for a while until they finally agreed to have it reprinted.

The service advisor just recently sent me the sticker in the mail for me to apply myself. However, I don't remember exactly where on the doorjamb it was located. I'd like to have it as close to original as possible. (I know, I'm a bit ****.) Can someone take a picture of their VIN label that shows where it is placed on the doorjamb?

I also wanted to get the tire pressure sticker replaced, but the service advisor tells me without the original there is no way to know which sticker was on there - supposedly there are several different ones. If he had the part number of the original he could get it but too late now...
 
  #2  
Old 09-07-2013 | 07:16 PM
pedalquickly's Avatar
pedalquickly
2nd Gear
Joined: Jun 2013
Posts: 70
Likes: 0
From: Pinson, Alabama
I started looking for my VIN a few month ago after purchasing an 06 and the only spot that I could find it was under the hood. It is printed big and has a clear sticker protecting it. I don't have any stickers in the door jambs..
 
  #3  
Old 09-07-2013 | 07:32 PM
kramseib's Avatar
kramseib
3rd Gear
Joined: Dec 2002
Posts: 254
Likes: 0
From: Powhatan, VA
Being concerned about placement will not bring you any more value on a resale. But, just as east to take a look at ANY other vehicle. I don't think MINI would be any different than other manufacturers.
 
  #4  
Old 09-08-2013 | 10:35 AM
Marquette MINI's Avatar
Marquette MINI
Thread Starter
|
2nd Gear
Joined: Jan 2006
Posts: 89
Likes: 8
Originally Posted by kramseib
Being concerned about placement will not bring you any more value on a resale.
Agreed, but I'm not asking this question for the sake of resale. I am just wondering if the sticker was closer to the door strike plate? Or closer to the bottom sill? I seem to recall that the tire pressure sticker was ABOVE the VIN sticker, which means that it might have been closer to the bottom of the door jamb.

FWIW, my other car is an Audi and the door VIN sticker is actually higher up on the door jamb, between the strike plate and the outside edge of the door jamb. So placement does vary by manufacturer.

Was just hoping that someone would have been kind enough to post a picture of his or her VIN sticker here so I could see exactly where it goes. Guess I'll just keep an eye out for other MINI drivers when I'm out and about and ask if I could look at theirs.
 
  #5  
Old 09-08-2013 | 10:37 AM
Marquette MINI's Avatar
Marquette MINI
Thread Starter
|
2nd Gear
Joined: Jan 2006
Posts: 89
Likes: 8
Originally Posted by pedalquickly
I started looking for my VIN a few month ago after purchasing an 06 and the only spot that I could find it was under the hood. It is printed big and has a clear sticker protecting it. I don't have any stickers in the door jambs..
Then your car has most likely had some body work done. It came from the factory with a VIN label and a tire pressure sticker on the driver side door jamb.
 
  #6  
Old 09-08-2013 | 02:39 PM
AlexQS's Avatar
AlexQS
5th Gear
Joined: Apr 2013
Posts: 731
Likes: 4
From: Near Portland, OR, USA
Here you go:

The VIN sticker is about two fingers below the door latch strike plate.

The edge of the tire sticker is right about where the curve in the door jam is.

There are two other little stickers, and they're about a key length from where the black plastic ends....

See photos.
 

Last edited by AlexQS; 09-14-2013 at 02:28 AM.
  #7  
Old 09-08-2013 | 06:49 PM
Marquette MINI's Avatar
Marquette MINI
Thread Starter
|
2nd Gear
Joined: Jan 2006
Posts: 89
Likes: 8
Perfect! Exactly what I needed to know. Thanks!
 
  #8  
Old 09-09-2013 | 10:22 PM
FredoinSF's Avatar
FredoinSF
6th Gear
Joined: Jul 2006
Posts: 1,154
Likes: 8
From: France and Reno/Tahoe
Originally Posted by Marquette MINI
Then your car has most likely had some body work done. It came from the factory with a VIN label and a tire pressure sticker on the driver side door jamb.
Reading the original post helps

Originally Posted by Marquette MINI
Several months ago I had both my rear quarter panels replaced under warranty on my 2006 MCS for rust damage underneath the taillights. In the process, the body shop failed to transfer or replace the VIN and tire pressure stickers, which I noticed about a month after. I went back and forth with the dealer for a while until they finally agreed to have it reprinted.

The service advisor just recently sent me the sticker in the mail for me to apply myself. However, I don't remember exactly where on the doorjamb it was located. I'd like to have it as close to original as possible. (I know, I'm a bit ****.) Can someone take a picture of their VIN label that shows where it is placed on the doorjamb?

I also wanted to get the tire pressure sticker replaced, but the service advisor tells me without the original there is no way to know which sticker was on there - supposedly there are several different ones. If he had the part number of the original he could get it but too late now...
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Peking Duck
F55/F56 :: Hatch Talk (2014+)
13
01-19-2021 03:17 AM
dgamblin
General MINI Talk
6
01-02-2021 02:57 PM
RobbyD
MINIs & Minis for Sale
11
01-29-2019 01:22 PM
vulkandino
MINIs & Minis for Sale
8
10-31-2015 08:29 PM
Levers_and_Gears
JCW Garage
0
09-28-2015 04:42 PM



Quick Reply: R50/53 Need help: VIN sticker placement on doorjamb



All times are GMT -7. The time now is 12:18 AM.