R55 Can't get wheels off
#26
#28
Can also try this:
Loosen all 4 lug nuts a little (1-2 full turns at the most).
Drive the car back and forth a little a few times at the curbside or
driveway, stopping very sharply; do this with the wheels turned at least a little.
This will often break the seal between the hub and the wheel.
Don't do this, fail, and give up and go on to drive the car normally without
re-tightening the lug nuts, or you could be in for a nasty surprise.
Loosen all 4 lug nuts a little (1-2 full turns at the most).
Drive the car back and forth a little a few times at the curbside or
driveway, stopping very sharply; do this with the wheels turned at least a little.
This will often break the seal between the hub and the wheel.
Don't do this, fail, and give up and go on to drive the car normally without
re-tightening the lug nuts, or you could be in for a nasty surprise.
#29
Can also try this:
Loosen all 4 lug nuts a little (1-2 full turns at the most).
Drive the car back and forth a little a few times at the curbside or
driveway, stopping very sharply; do this with the wheels turned at least a little.
This will often break the seal between the hub and the wheel.
Don't do this, fail, and give up and go on to drive the car normally without
re-tightening the lug nuts, or you could be in for a nasty surprise.
Loosen all 4 lug nuts a little (1-2 full turns at the most).
Drive the car back and forth a little a few times at the curbside or
driveway, stopping very sharply; do this with the wheels turned at least a little.
This will often break the seal between the hub and the wheel.
Don't do this, fail, and give up and go on to drive the car normally without
re-tightening the lug nuts, or you could be in for a nasty surprise.
Mike
Last edited by UH60Hwkdrvr; 11-28-2013 at 09:24 PM.
#30
If you can kick your car off of jack stands you must have some insane legs or your car isn't supported properly. Very unlikely it's the former
#31
Well I finally got around to rotating the tires. I picked up a good spray penetrating lube and sprayed the area between the wheel and disc well, let sit for 6 hours. Two wheels came off without much trouble the other two still would not move so I put the lugs back in but left them loose two turns, drove the car back and forth a few times hitting the brakes hard. Both wheels came off but were still very tight. All 4 wheels had a lot of rust around the hubs. I lobbed everything with white lithium grease and put the tires back on. Should be go to go for the next rotation.
Thread
Thread Starter
Forum
Replies
Last Post
SosoMINI
MINI Parts for Sale
30
11-22-2015 03:17 PM