R55 Custom pillar pod project

Reply Subscribe

Thread Tools

Search this Thread

03-24-2018, 09:23 AM

Joshua Brightbill

Neutral

Thread Starter

Join Date: Mar 2018

Location: Reading, PA

Posts: 6

Likes: 1

Received 0 Likes on 0 Posts

Custom pillar pod project

I covered the original pillar in aluminum foil to protect it, then fitted some 2 inch PVC pipe in place and added some foam for extra space.

Next I started the fiberglass and resin layers. I did between 2 and 3 as needed.

Its ugly now, but it will take its shape.

Letting it cure before more detailed triming.

Reply Like

03-24-2018, 09:33 AM

Joshua Brightbill

Neutral

Thread Starter

Join Date: Mar 2018

Location: Reading, PA

Posts: 6

Likes: 1

Received 0 Likes on 0 Posts

Layers of fiberglass body filler bondo. The original pillar is out by this point. Lots of sanding ahead.

Tools make life easier.

Just working to get it nice and even. I repete the bondo filling as needed, then i move to red putty to fill the smaller imperfections. After that i prime it.

Done with that jazz, and ready for plasti dip. I cleared the foam out of the pillar with a knife and a dremmel.

Reply Like

03-24-2018, 09:38 AM

Joshua Brightbill

Neutral

Thread Starter

Join Date: Mar 2018

Location: Reading, PA

Posts: 6

Likes: 1

Received 0 Likes on 0 Posts

I made litte inserts to keep the dip out of the pods so i wouldnt have to sand the inside again. Saving time and making sure the gauges fit properly.

Reply Like