R55 "empty" 2-pin connector
#1
SOLVED - "empty" 2-pin connector
Update: Better picture of the 2 pin connector.
I was able to get some help from MiniMania. This connector was "obsoleted" by the introduction of an updated thermostat housing. I had the thermostat replaced recently, which is why the connector is (a) so clean, and (b) empty.
------------------
First post on this forum. If this is in the wrong place, I apologize.
2013 Clubman Cooper S. Beneath the air duct which runs from the MAF to the turbo, there is a 2-pin connector which is empty. But it is so clean, I don't think "empty" is the correct configuration. I have not been able to find any information about this connector, so I am kind of at a loss.
Couple of pics attached. One is the connector. The other pic provides a sense of where the connector is located.
A P0171 code is what got me looking. My first find was the air duct was cracked; I did a temporary repair on the duct, while waiting to receive a new one. But the fault code is still there, even after clearing.
Any ideas?
Thanks.
I was able to get some help from MiniMania. This connector was "obsoleted" by the introduction of an updated thermostat housing. I had the thermostat replaced recently, which is why the connector is (a) so clean, and (b) empty.
------------------
First post on this forum. If this is in the wrong place, I apologize.
2013 Clubman Cooper S. Beneath the air duct which runs from the MAF to the turbo, there is a 2-pin connector which is empty. But it is so clean, I don't think "empty" is the correct configuration. I have not been able to find any information about this connector, so I am kind of at a loss.
Couple of pics attached. One is the connector. The other pic provides a sense of where the connector is located.
A P0171 code is what got me looking. My first find was the air duct was cracked; I did a temporary repair on the duct, while waiting to receive a new one. But the fault code is still there, even after clearing.
Any ideas?
Thanks.
Last edited by 2013alice; 09-07-2021 at 09:52 AM. Reason: added a better pic of the conn
Thread
Thread Starter
Forum
Replies
Last Post
MrSurly
Stock Problems/Issues
8
08-29-2018 04:44 PM