When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
hey, few more questions... were these easy to install? did an application solution or squeegee come with it? how do you know how far apart it fits on the mini? i should have my piece in a day or two!
I thought it was easy...Not sure on the measurements...I can measure mine and get back to you. I did it the dry way. Taped down the stripes where I wanted, pealed back half of the backing, and squeegeed down that half, then pulled the backing off the other side, and squeegeed down that side...on the white piping, I too the backing off first...then started the end and did one lay down, and squeegeed. There were a few little bubbles that I punchered with a needle and squeegeed. It didn't take them out fully until the car sat in the sun.
ok so it does come pre-stuck with some glue on it. did you have to cut it or were they 2 fit pieces?
They were cut...and I though they were too short, but once I laid them out...it was tight. But vinyl stretches so I made sure there was some over the edge of the belt line when I started, and while applying, I ended up with about and inch extra that I cut off and tucked in.