R56 90 degree BTDC cylinder 1 or 2 question
#1
90 degree BTDC cylinder 1 or 2 question
Good evening folks. I have the cylinders at 90 degrees BTDC (all cylinders are at the same height), but I was wondering if the cams are timed off cylinder 1 (closest to passenger side) moving towards TDC or cylinder 2? Since they are moving in opposite directions, I would think the timing is based off one or the other. Just wanted to make sure everything is lined up. Thanks y'all. This site has been fantastic.
#2
Good evening folks. I have the cylinders at 90 degrees BTDC (all cylinders are at the same height), but I was wondering if the cams are timed off cylinder 1 (closest to passenger side) moving towards TDC or cylinder 2? Since they are moving in opposite directions, I would think the timing is based off one or the other. Just wanted to make sure everything is lined up. Thanks y'all. This site has been fantastic.
Thread
Thread Starter
Forum
Replies
Last Post
ron123
R56 :: Hatch Talk (2007+)
28
10-16-2023 01:53 PM
sevin
R50/R53 :: Hatch Talk (2002-2006)
37
12-23-2015 11:20 AM
AoxoMoxoA
R50/R53 :: Hatch Talk (2002-2006)
3
11-04-2015 06:32 AM