R50/53 Mini code reader advice
#1
Mini code reader advice
Hello all. I am looking for a relatively inexpensive code reader to read the mini engine fault codes. I have been experiencing issues with my r53 going into limp mode and sometimes not starting properly after many many attempts. The OBDII gives a p0229 "throttle position sensor" code but thats very general. Anyone know of a good code reader that will go into more detail and isnt going to break the bank? Dealer and most mini service are charging $140 avg to run a diagnostic on the car.
#2
#3
$50 sounds about reasonable for a diagnostic. Whereabouts are you located? Anymore infro on the device you are talking about?
#4
#5
+1
Saves a trip:
Reviews here on what it will do.
https://www.northamericanmotoring.co...d-q-and-a.html
Saves a trip:
Reviews here on what it will do.
https://www.northamericanmotoring.co...d-q-and-a.html
__________________
MINI Guru/ MINI Owner Since 2004 | NEW Lifetime Part Replacement | Local Pickup
Milltek | Genuine MINI | Forge Motorsport | NM Engineering | ECS Performance | M7 Speed
Customer Service Hours: 8am-8pm EST|Sales Team Hours: 8am-11pm | SAT 10am-7pm 800.924.5172
MINI Guru/ MINI Owner Since 2004 | NEW Lifetime Part Replacement | Local Pickup
Milltek | Genuine MINI | Forge Motorsport | NM Engineering | ECS Performance | M7 Speed
Customer Service Hours: 8am-8pm EST|Sales Team Hours: 8am-11pm | SAT 10am-7pm 800.924.5172
#6
+1
Saves a trip:
Reviews here on what it will do.
https://www.northamericanmotoring.co...d-q-and-a.html
Saves a trip:
Reviews here on what it will do.
https://www.northamericanmotoring.co...d-q-and-a.html
#7
You will select the OBD2 icon( on the left) and it will reads all the Jeep codes. Then go to foxwell site after you register the scan tool ( on it ) and you can get the Jeep updates.
The unit comes programmed from the factory with the BMW / MINI / RR specific software which is the icon on the center left.
The unit comes programmed from the factory with the BMW / MINI / RR specific software which is the icon on the center left.
__________________
MINI Guru/ MINI Owner Since 2004 | NEW Lifetime Part Replacement | Local Pickup
Milltek | Genuine MINI | Forge Motorsport | NM Engineering | ECS Performance | M7 Speed
Customer Service Hours: 8am-8pm EST|Sales Team Hours: 8am-11pm | SAT 10am-7pm 800.924.5172
MINI Guru/ MINI Owner Since 2004 | NEW Lifetime Part Replacement | Local Pickup
Milltek | Genuine MINI | Forge Motorsport | NM Engineering | ECS Performance | M7 Speed
Customer Service Hours: 8am-8pm EST|Sales Team Hours: 8am-11pm | SAT 10am-7pm 800.924.5172
Thread
Thread Starter
Forum
Replies
Last Post
Mini Mania
Vendor Announcements
0
02-16-2016 08:26 AM