R50/53 Another alternative to the stock belt tensioner tool
#1
Another alternative to the stock belt tensioner tool
Disclaimer:
I accept no liability for personal or property damage resulting from emulating this method.
Like so many before me, I saw that the belt tensioner has a 3/8" square hole and assumed that I'd be able to use my ratchet w/ a cheater bar to take tension off the serpentine belt.... and like them, I found that the engine is about 1/4" too close to the right frame to actually get a ratchet in there. Given that I didn't have a 3/8" breaker bar, and that my alternator was completely failed, I found a non traditional solution that worked very well.
It turns out that a 1/4" 3/8 drive socket fits nicely into the aforementioned 3/8" square hole, while clearing the frame:
One then simply needs a long enough open end wrench (or spanner, if you prefer) and a jack.
Simply jack the tensioner up until you can remove the belt. I was a bit hesitant at first, but this turned out to be really drama free.
I accept no liability for personal or property damage resulting from emulating this method.
Like so many before me, I saw that the belt tensioner has a 3/8" square hole and assumed that I'd be able to use my ratchet w/ a cheater bar to take tension off the serpentine belt.... and like them, I found that the engine is about 1/4" too close to the right frame to actually get a ratchet in there. Given that I didn't have a 3/8" breaker bar, and that my alternator was completely failed, I found a non traditional solution that worked very well.
It turns out that a 1/4" 3/8 drive socket fits nicely into the aforementioned 3/8" square hole, while clearing the frame:
One then simply needs a long enough open end wrench (or spanner, if you prefer) and a jack.
Simply jack the tensioner up until you can remove the belt. I was a bit hesitant at first, but this turned out to be really drama free.
The following 2 users liked this post by ST3ALTHPSYCH0:
Al Broughton (06-09-2020),
philwarner (02-22-2018)
#2
More than one way to skin a cat. Looks like it worked pretty well.
When I changed my belt I made a much longer grenade pin to hold the tensioner open out of some coat hanger wire. Made it much easier to get it into the hole without having to wedge my hand between the engine and frame rail.
When I changed my belt I made a much longer grenade pin to hold the tensioner open out of some coat hanger wire. Made it much easier to get it into the hole without having to wedge my hand between the engine and frame rail.
The following users liked this post:
cosmoKenney (07-01-2022)
Thread
Thread Starter
Forum
Replies
Last Post
arth4
MINI Parts for Sale
7
08-09-2016 10:02 AM
VII
R50/R53 :: Hatch Talk (2002-2006)
0
05-26-2014 03:27 PM
rsbf21
R50/R53 :: Hatch Talk (2002-2006)
7
09-23-2011 08:37 AM
JAYB
All other MINI parts and items for Sale (archive)
5
07-18-2008 07:58 PM
TerryTCL
Chicago MINI Motoring Club
7
11-13-2006 01:58 PM