03 clutch replacement help
#1
03 clutch replacement help
I'm looking for a little help. I just finished rebuilding my 03 s with just a little over 365,000 miles. Good news, got it all back together and it fired right up. Since I had the engine out I decided to replace the original clutch, pressure plate, dual mass flywheel, throw out bearing, and guide. Now the part I can't figure out. The throw out bearing comes into contact with the pressure plate splines after about a 1/2" of travel, thus the slave cylinder does not have enough travel to fully release the clutch. I dropped the engine again figuring I had missed something, I cannot find anything not put together correctly. Any suggestions would be appreciated. Thanks,
Nik
Nik
#2
Thread
Thread Starter
Forum
Replies
Last Post
hernlui
1st Gen Countryman (R60) Talk (2010-2015)
3
07-24-2016 09:39 AM
fjohn624
R56 :: Hatch Talk (2007+)
7
07-20-2016 08:30 PM
thelawson
R56 :: Hatch Talk (2007+)
4
04-13-2016 11:04 AM