MCS 2011: P0010 code
#1
MCS 2011: P0010 code
Before I go down the rabbit hole (again), I thought I'd check quickly with you fine folks.
2011 MCS w/ 174K miles. Engine went into limp mode, CEL code P0010.
Should I follow this thread: https://www.northamericanmotoring.co...code-help.html
or is there a better way to move forward?
Any thoughts/comments are always very much appreciated.
Edit: Engine is idling a little rough - some surges up to 1.5K RPM and then back to 750.
2011 MCS w/ 174K miles. Engine went into limp mode, CEL code P0010.
Should I follow this thread: https://www.northamericanmotoring.co...code-help.html
or is there a better way to move forward?
Any thoughts/comments are always very much appreciated.
Edit: Engine is idling a little rough - some surges up to 1.5K RPM and then back to 750.
Last edited by Dcb22; 09-21-2021 at 05:44 PM.
#2
P0010 is the intake VVT solenoid, which was replaced. Below is a video if anyone ever gets this code and needs assistance:
Just be prepared that some later Minis use a torx bolt instead of a 10mm bolt for the solenoid. The Torx is a 27 or 30 size, but it is very easily stripped. The metal on these solenoid torx bolts (front and back) is like butter and strips with very light torque.
Just be prepared that some later Minis use a torx bolt instead of a 10mm bolt for the solenoid. The Torx is a 27 or 30 size, but it is very easily stripped. The metal on these solenoid torx bolts (front and back) is like butter and strips with very light torque.
Thread
Thread Starter
Forum
Replies
Last Post
7thmoosefromtheleft
Stock Problems/Issues
3
01-09-2019 01:08 PM