Re-drill rotors to 5 lug 5x130mm pattern?
#2
Ok... I'm bored so I'll bite...
I am 99.9% sure the wheel bolts go through the rotor and into the hub ,so it's not just a matter of more holes in the brake rotor.
If you own the machining equipment you might be able to make them work, but I think it'll be a cold day in hell before you find any machine shop willing to take on that level of liability. The consequences of failure would obviously be catastrophic.
I am 99.9% sure the wheel bolts go through the rotor and into the hub ,so it's not just a matter of more holes in the brake rotor.
If you own the machining equipment you might be able to make them work, but I think it'll be a cold day in hell before you find any machine shop willing to take on that level of liability. The consequences of failure would obviously be catastrophic.
Thread
Thread Starter
Forum
Replies
Last Post
unxpectederror
Drivetrain (Cooper S)
5
10-22-2015 12:16 PM