Bump bracket MOD?
#1
Join Date: Jan 2006
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Bumper bracket MOD?
I am about to purchase some O.Z. Ultraleggera's with 215/45/17 tires.
I have read up on this combination and understand that it may rub a bit. I have also read that the rear bump brackets can be modified to make them work.
Does anyone have pictures of this bracket mod. I would like to do this before i have a problem with the rub.
Thanks in advance.
I have read up on this combination and understand that it may rub a bit. I have also read that the rear bump brackets can be modified to make them work.
Does anyone have pictures of this bracket mod. I would like to do this before i have a problem with the rub.
Thanks in advance.
Last edited by WorksMiniS; 04-24-2007 at 06:26 PM.
#2
The Ultraleggera's are ET37, so my setup is close to what you're planning to install.
I just installed a set of Enkei GTC01's (ET38) with GY F1's 215/45/17. I have the JCW suspension. Alex said that I may have an issue with the tires rubbing on the bumper bracket inner rear fender well plastic 'bump' at the rear of the wheel well, but, so far I have not experienced any clearance issues. My guess is that you'll probably be OK, unless your car is lowered more than about 1".
I just installed a set of Enkei GTC01's (ET38) with GY F1's 215/45/17. I have the JCW suspension. Alex said that I may have an issue with the tires rubbing on the bumper bracket inner rear fender well plastic 'bump' at the rear of the wheel well, but, so far I have not experienced any clearance issues. My guess is that you'll probably be OK, unless your car is lowered more than about 1".
Thread
Thread Starter
Forum
Replies
Last Post